Nissan Rogue Service Manual: U1000 CAN COMM circuit
DTC Logic
DTC DETECTION LOGIC
|
DTC |
CONSULT |
Detection Condition |
Possible Cause |
| U1000 | CAN COMM CIRC [U1000] | When combination meter is not transmitting or receiving CAN communication signals for 2 seconds or more. | CAN communication system |
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC
- Turn ignition switch ON and wait 2 seconds or more.
- Check “Self Diagnostic Result” of “METER/M&A”.
Is DTC "U1000" displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".
NO >> Refer to GI-41, "Intermittent Incident".
U1010 control unit (CAN)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Condition
Possible Cause
U1010
CONTROL UNIT (CAN ...
Other materials:
U1000 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
Operating range
Operating range
The Intelligent Key functions can only be used
when the Intelligent Key is within the specified
operating range from the request switch 1 .
When the Intelligent Key battery is discharged or
strong radio waves are present near the operating
location, the Intelligent Key op ...
Combination meter
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to PG-77, "Removal
and Installation".
Remove the cluster lid A. Refer to IP-20, "Removal and
Installation".
Remove screws (A), from the combination meter (1).
...
