Nissan Rogue manuals

Nissan Rogue Service Manual: U0102 lost communication (Transfer)

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
U0102 LOST COMM (TRANSFER) (Lost Communication With Transfer Case Control Module) When the ignition switch is ON, TCM is unable to receive the CAN communications signal from AWD control unit continuously for 2 seconds or more.

POSSIBLE CAUSE

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1.  Start the engine and wait for at least 5 seconds.
  2.  Check the DTC.

Is “U0102” detected? YES >> Go to TM-104, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN-17, "Trouble Diagnosis Flow Chart".

U0100 lost communication (ECM A)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0100 LOST COMM (ECM A) (Lost Communication With ECM/P ...

U0140 lost communication (BCM)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0140 LOST COMM (BCM) (Lost Communication With Body Co ...

Other materials:

Side air spoiler
Exploded View Side air spoiler Clip Removal and Installation REMOVAL  Remove side air spoiler bolts (A). 1: Side air spoiler B: Clips Release clips using suitable tool (A) and remove side air spoiler (1). : Clips INSTALLATION Installation is in the rev ...

S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position. Diagnosis Procedure Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram" ...

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector  ABS actuator and electric unit (control u ...

© 2014-2022 Copyright www.nirogue.com