Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
Diagnosis items | Symptom (Power switch ON) | Low tire pressure warning lamp | Cause | Action |
Low tire pressure warning lamp | The low tire pressure warning lamp illuminates for 1 second, then turns OFF. | ![]() |
Wake-up operation for all tire pressure sensors at wheels is completed. | No system malfunctions |
The low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds. | ![]() |
Wake-up operation for all tire pressure sensors at wheels is not completed. | Perform the ID registration for all tire pressure sensors at wheels. Refer to WT-21, "Work Procedure". | |
The low tire pressure warning lamp blinks once. | ![]() |
The front left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front left wheel. Refer to WT-21, "Work Procedure". | |
The low tire pressure warning lamp repeats blinking twice. | ![]() |
The front right tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front right wheel. Refer to WT-21, "Work Procedure". | |
The low tire pressure warning lamp repeats blinking for 3 times. | ![]() |
The rear right tire pressure sensor is not activated | Perform the ID registration for the tire pressure sensor at rear right wheel. Refer to WT-21, "Work Procedure". | |
The low tire pressure warning lamp repeats blinking for 4 times. | ![]() |
The rear left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at rear left wheel. Refer to WT-21, "Work Procedure". | |
The low tire pressure warning lamp turns ON and stays illuminated. | ![]() |
Low tire pressure | Check the tire pressure for all wheels and adjust to the specified value. Refer to WT-65, "Tire Air Pressure". | |
The low tire pressure warning lamp repeats blinking at 0.5-second intervals for 1 minute, and then stays illuminated. | ![]() |
The combination meter fuse is open or removed (or pulled out). | Check and install the combination meter fuse. If necessary, replace the fuse. | |
The BCM harness connector is removed. | Check the connection conditions of the BCM harness connector, and repair if necessary. | |||
Tire Pressure Monitoring System (TPMS) malfunction. |
|
NOTE: If tire pressure sensor wake-up operation is not completed for two or more tire pressure sensors, the applicable low tire pressure warning lamp blinking patterns are displayed continuously.
(Example: Blinks once/OFF/blinks 3 times = Wake-up operation is not completed at the front left wheel and rear right wheel tire pressure sensors.)
Steering angle sensor
Exploded View
Combination switch
Steering angle sensor
Spiral cable
Removal and Installation
Removal and Installation
Remove the spiral cable. Refer to SR-15, "Exploded View".
Remove screws (A) and then remove steering angle sensor (1).
INSTALLATI ...
NISSAN Intelligent Key® (if so equipped)
WARNING
Radio waves could adversely affect
electric medical equipment. Those who
use a pacemaker should contact the
electric medical equipment manufacturer
for the possible influences before
use.
The Intelligent Key transmits radio
waves when the bu ...
Glass lid
Exploded View
Panoramic roof glass
Glass lid
Side trim covers (LH/RH)
Front drain hose (LH/RH)
Moonroof motor assembly
Sunshade motor assembly
Moonroof front bracket (LH/RH)
Moonroof rear bracket (LH/RH)
Rear drain hose (LH/RH)
Moonroof unit assembly ...