Nissan Rogue manuals

Nissan Rogue Service Manual: The parking brake release warning continues displaying, or does not display

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / Symptom diagnosis / The parking brake release warning continues displaying, or does not display

Description

Diagnosis Procedure

1.CHECK PARKING BRAKE WARNING LAMP OPERATION

  1.  Start engine.
  2.  Check the operation of the brake warning lamp while operating the parking brake.

Check parking brake warning lamp operation

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> GO TO 2.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

  1.  Turn ignition switch OFF.
  2.  Check the parking brake switch signal circuit. Refer to MWI-64, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK PARKING BRAKE SWITCH UNIT

Check the parking brake switch. Refer to MWI-64, "Component Inspection".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> Replace parking brake switch. Refer to PB-7, "Exploded View".

The oil pressure warning continues displaying, or does not display
Description The low oil pressure warning message stays on when oil pressure is normal.  The low oil pressure warning message stays off when oil pressure is low. Diagnosis Procedure ...

The low washer fluid warning continues displaying, or does not display
Description The warning is still displayed even after washer fluid is added. The warning is not displayed even though the washer tank is empty. Diagnosis Procedure 1.CHECK WASHER FLUID LEVEL ...

Other materials:

Removal and installation
REAR PROPELLER SHAFT Exploded View Center bearing mounting bracket (upper) Clip Propeller shaft assembly Center bearing mounting bracket (lower) : Vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL  Shif ...

How to erase permanent DTC
Description OUTLINE When a DTC is stored in ECM When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same malfunction is detecte ...

Depending on the equipment version: driving out of a parking space using the parking assistant
Principle The system makes driving out of parallel parking spaces easier. General information Steptronic transmission The parking assistant calculates an optimal line for pulling out of a parking space and takes control of the following functions during the maneuver: Steering. Accelerating and br ...

© 2014-2022 Copyright www.nirogue.com