Nissan Rogue Service Manual: Symptom diagnosis
THE SPORT MODE INDICATOR LAMP DOES NOT TURN ON
Description
The SPORT mode indicator lamp does not turn ON when the SPORT mode switch is operated.
Diagnosis Procedure
1.CHECK SPORT MODE INDICATOR LAMP FUNCTION
Perform combination meter self-diagnosis mode and check test order 10. Refer to MWI-19, "Description".
Is the check result normal? YES >> GO TO 2.
NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
2.CHECK DTC (TCM)
With CONSULT
- Start the engine.
- Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 3.
3.CHECK DTC (ECM)
With CONSULT
Check “Self Diagnostic Results” in “ENGINE”.
Is any DTC detected? YES >> Check DTC detected item. Refer to EC-93, "DTC Index".
NO >> GO TO 4.
4.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 5.
5.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
- Select “Data Monitor” in “METER/M&A”.
- Select “SPORT MODE IND”.
- Check that “SPORT MODE IND” turns ON/OFF when SPORT mode switch is operated. Refer to MWI-24, "Reference Value".
Is any DTC detected? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 6.
6.CHECK SPORT MODE SWITCH CIRCUIT
Check SPORT mode switch circuit. Refer to DMS-13, "Diagnosis Procedure".
Is any DTC detected? YES >> INSPECTION END
NO >> Repair or replace malfunctioning parts.
DTC/circuit diagnosis
SPORT MODE SWITCH
Component Function Check
1. CHECK SPORT MODE SWITCH OPERATION
Turn ignition switch ON.
Check SPORT mode indicator lamp turns ON/OFF on combination meter
when t ...
Removal and installation
SPORT MODE SWITCH
Removal and Installation
REMOVAL
Remove instrument lower panel LH. Refer to IP-14, "Exploded View".
Remove SPORT mode switch.
INSTALLATION
Installat ...
Other materials:
Wiring diagram
MANUAL AIR CONDITIONING SYSTEM
Wiring Diagram
...
Spiral cable
Exploded View
Combination switch
Steering angle sensor
Spiral cabl
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Do not use the air tools or electric t ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work flow
OVERALL SEQUENCE
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.CHECK SYMPTOM
...
