Nissan Rogue Service Manual: Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
- Start the engine.
- Shift selector lever.
- Check that the selector lever position and the shift position indicator on the combination meter are identical.
Is the inspection result normal? YES >> INSPECTION END
NO >> Go to TM-182, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Start the engine.
- Select “Data Monitor” in “TRANSMISSION”.
- Select “RANGE”.
- Shift selector lever.
- Check that selector lever position, “RANGE” on CONSULT screen, and shift position indicator display on combination meter are identical.
Is the check result normal? YES >> INSPECTION END
NO-1 (“RANGE” is changed but is not displayed on shift position indicator.>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-2 (“RANGE” and shift position indicator are different.)>>Check “Self Diagnostic Result” in “TRANSMISSION”.
NO-3 (Specific “RANGE” is not displayed on shift position indicator.)>>Check “Self Diagnostic Result” in “METER/M&A”.
O/D off indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YE ...
Shift lock system
Component Function Check
1.CHECK SHIFT LOCK OPERATION (PART 1)
Turn ignition ON.
Shift the selector lever to “P” position.
Attempt to shift the selector lever to any oth ...
Other materials:
Removal and installation
FRONT AIR CONTROL
Removal and Installation
REMOVAL
Release the front air control clips and pawls using a suitable
tool.
: Metal clip
: Pawl
Disconnect the harness connector from the front air control (1)
and remove.
INSTALLATION
Installation is in the reverse order of ...
Removal and installation
DRIVE PINION OIL SEAL
Exploded View
Rear final drive assembly
Drive pinion oil seal
Electric controlled coupling assembly
Oil seal lip
Always replace after every
disassembly.
: Apply gear oil.
: Apply multi-purpose grease.
Removal and Installation
REMOVAL
Remove ...
P0222, P0223 TP sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0222
TP SEN 1/CIRC-B1
(Throttle/pedal position sensor/switch ″B″
circuit low)
An excessively low voltage from the TP sensor 1 is se ...
