Idle Speed
Condition | Specification |
No load* (in P or N position) | 650 ± 50 rpm |
*: Under the following conditions
Ignition Timing
Condition | Specification |
No load* (in P or N position) | 10 ± 2° BTDC |
*: Under the following conditions
Calculated Load Value
Condition | Specification (Using CONSULT or GST) |
At idle | 10 – 35 % |
At 2,500 rpm | 10 – 35 % |
Mass Air Flow Sensor
Supply voltage | Battery voltage (11 – 14 V) |
Output voltage at idle | 1.3 – 1.6 V* |
Mass air flow (Using CONSULT or GST) | 1.0 – 4.0 g/s at idle* 4.0 – 10.0 g/s at 2,500 rpm* |
*: Engine is warmed up to normal operating temperature and running under no load.
Primary speed sensor
Exploded View
Transaxle assembly
O-ring
Primary speed sensor
: Always replace after every
disassembly.
: N·m (kg-m, in-lb)
: Apply CVT fluid
Removal and Installation
REMOVAL
Remove the engine undercover. Refer to EXT-37, "ENGINE UNDER COVER
: Removal and Ins ...
Sun visors
Sun visors
To block glare from the front, swing down the
main sun visor.
To block glare from the side, remove the
main sun visor from the center mount and
swing the visor to the side.
To extend the sun visor, slide in or out as
needed.
CAUTION
Do not ...
If your vehicle overheats
WARNING
Do not continue to drive if your vehicle
overheats. Doing so could cause engine
damage or a vehicle fire.
To avoid the danger of being scalded,
never remove the radiator or coolant
reservoir cap while the engine is still
hot. When the radiator o ...