Nissan Rogue Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch signal to the combination meter.
Component Function Check
1. CHECK COMBINATION METER INPUT SIGNAL
- Ignition ON.
- Monitor seat belt warning lamp while fastening and unfastening the driver seat belt buckle.
Is the inspection result normal? YES >> Inspection End.
NO >> Refer to WCS-43, "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WCS-29, "Wiring Diagram".
1. CHECK COMBINATION METER INPUT SIGNAL
- Turn ignition switch ON.
- Check voltage between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 2.
2. CHECK SEAT BELT BUCKLE SWITCH LH CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector M76 and seat belt buckle switch LH harness connector B87.
- Check continuity between combination meter harness connector M76 terminal 28 and seat belt buckle switch LH harness connector B87 terminal 1.
- Check continuity between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connector.
3. CHECK SEAT BELT BUCKLE SWITCH LH GROUND CIRCUIT
Check continuity between seat belt buckle switch LH harness connector B87 terminal 2 and ground.
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace harness or connector.
Component Inspection
1. CHECK SEAT BELT BUCKLE SWITCH
- Turn ignition switch OFF.
- Disconnect the seat belt buckle switch LH connector.
- Check continuity between the seat belt buckle switch LH terminals 1 and 2.
Is the inspection result normal? YES >> Inspection End.
NO >> Replace the seat belt buckle switch LH. Refer to SB-11, "FRONT SEAT BELT BUCKLE : Removal and Installation".
Meter buzzer circuit
Description
The buzzer for the warning chime system is installed in the combination
meter.
The combination meter sounds the buzzer based on the signals transmitted
from various units.
C ...
Parking brake switch signal circuit
Component Function Check
1.CHECK PARKING BRAKE SWITCH OPERATION
Check that brake warning lamp in combination meter turns ON/OFF when parking
brake is actuated.
Is the inspection result normal?
...
Other materials:
B0021 side curtain air bag module IH
DTC Logic
DTC DETECTION LOGIC
CONSULT name
DTC
DTC detecting condition
Repair order
CURTAIN AIRBAG MODULE LH CIRCUIT
[OPEN]
B0021
LH side curtain air bag module circuit
is open.
Refer to SRC-55, "Diagnosis Procedure".
CURTA ...
P0847 transmission fluid pressure SEN/SW B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0847
FLUID PRESS SEN/SW B
(Transmission Fluid Pressure Sensor/Switch B
Circuit Low)
When all of the following conditions are satisfied and this sta ...
P0078 EVT control solenoid valve
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condit
P0078
EX V/T ACT/CIRC-B1
(Exhaust valve control solenoid circuit bank
1)
An improper voltage is sent to the ECM through exhaust valve timing
co ...
