
Roof rack (if so equipped)
Genuine NISSAN accessory cross bars are available through your NISSAN dealer. Contact an NISSAN dealer for crossbar or other equipment information.
Always distribute the luggage evenly on the cross bars. Do not load more than 150 lb (68 kg) on the cross bars. Observe the maximum load limit shown on the cross bars or roof carriers when you attach them on the roof cross bars. Contact an NISSAN dealer for crossbar or other equipment information.
Do not apply any load directly to the roof side rails. Cross bars must be installed before applying load/cargo/luggage to the roof of the vehicle.
Be careful that your vehicle does not exceed the Gross Vehicle Weight Rating (GVWR) or its Gross Axle Weight Rating (GAWR front and rear). The GVWR and GAWR are located on the F.M.V.S.S. or C.V.M.S.S. certification label (located on the driver’s door pillar). For additional information regarding GVWR and GAWR, refer to “Vehicle loading information” in the “Technical and customer information” section of this manual.
WARNING
|
| CAUTION Always install the cross bars onto the roof side rails before loading cargo of any kind. Loading cargo directly onto the roof side rails or the vehicle’s roof may cause vehicle damage. |
Luggage hooks
Divide-n-hide® adjustable floor (if so equipped)P0340 CMP sensor (phase)
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting cond
P0340
CMP SEN/CIRC-B1
(Camshaft position sensor ″A″ circuit bank
1 or single sensor)
The cylinder No. signal is not sent to ECM ...
Removal and installation
HOOD
Exploded View
Hood hinge (RH)
Hood
Hood side seal
Hood front seal
Hood center seal
Bumper rubber
Hood insulator
Hood rod clamp
Hood support rod
Hood rod grommet
Hood hinge (LH)
HOOD ASSEMBLY
HOOD ASSEMBLY : Removal and Instal ...
P0460 fuel level sensor
DTC Description
DTC DETECTION LOGIC
When the vehicle is parked, naturally the fuel level in the fuel tank is
stable. It means that output signal of the
fuel level sensor does not change. If ECM senses sloshing signal from the
sensor, fuel level sensor malfunction
is detected.
DTC No. ...