Nissan Rogue manuals

Nissan Rogue Service Manual: Repairing material

Foam Repair

During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.

URETHANE FOAM APPLICATIONS

Use commercially available Urethane foam for sealant (foam material) repair of material used on vehicle.

<Urethane foam for foaming agent> 3Mâ„¢ Automixâ„¢ Flexible Foam 08463 or equivalent

Read instructions on product for fill procedures.

Example of foaming agent filling operation procedure

  1.  Fill procedures after installation of service part.
  1.  Eliminate foam material remaining on vehicle side.
  2.  Clean area after eliminating form insulator and foam material.
  3.  Install service part.
  4.  Insert nozzle into hole near fill area and fill foam material or fill enough to close gap with the service part.

Urethane foam applications

  1. Urethane foam
  2. Nozzle insert hole

Front

  1. Fill procedures before installation of service part.
  1.  Eliminate foam material remaining on vehicle side.
  2.  Clean area after eliminating foam insulator and foam material.
  3.  Fill foam material on wheelhouse outer side.

Urethane foam
A. Fill while avoiding flange area
Front

Urethane foam applications

NOTE: Fill enough to close gap with service part while avoiding flange area.

  1.  Install service part.

NOTE: Refer to label for information on working times.

Preparation
...

Body component parts
Underbody Component Parts Both sided anti-corrosive precoated steel portions High strength steel (HSS) portions: 440 MPa Both sided anti-corrosive steel and HSS portions: 440 MPa CA ...

Other materials:

Towing safety
Trailer hitch Your vehicle may be equipped with an optional trailer tow package. The trailer tow package includes a receiver-type frame mounted hitch. This hitch is rated for the maximum towing capacity of this vehicle when the proper towing equipment is used. Choose a proper ball mount and hi ...

Glove box assembly and housing
Removal and Installation REMOVAL  Release instrument side finisher (RH) (1) pawls using a suitable tool and remove. : Pawl NOTE: LH side shown; RH similar. Release the glove box damper (1) from the glove box assembly (2) as shown. Release the glove box assembly pawls ...

DTC/circuit diagnosis
P1610 LOCK MODE Description ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal. DTC Logic DTC DETECTION LOGIC NOTE:  If DTC B1610 is displayed with DTC U1000, fi ...

© 2014-2025 Copyright www.nirogue.com