Nissan Rogue Service Manual: Removal and installation

Performance test

Inspection INSPECTION PROCEDURE  Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge.  Start the engine, and set to the following condition. Test co ...

Compressor

Exploded View Compressor Removal and Installation REMOVAL Discharge the refrigerant. Refer to HA-23, "Recycle Refrigerant".  Remove the engine under cover. Refer to EX ...

Other materials:

P0890 TCM
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0890 TCM (Transmission Control Module Power Relay Sense Circuit Low) When all of the following conditions are satisfied and this state is maint ...

Retained power operation does not operate properly
Diagnosis Procedure 1.CHECK FRONT DOOR SWITCH Check (LH and RH) front door switches. Refer to DLK-24, "Front Door Switch". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CONFIRM THE OPERATION Confirm the operat ...

How to erase permanent DTC
Description OUTLINE When a DTC is stored in ECM When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same malfunction is detecte ...