Nissan Rogue Service Manual: Removal and installation
STARTER MOTOR
Exploded View
REMOVAL
- Transaxle assembly
- Starter motor
- Lower bolt
- Upper bolt
Removal and Installation
REMOVAL
- Remove battery tray. Refer to PG-77, "Removal and Installation".
- Remove terminal B nut and terminal B harness.
- Remove terminal S nut and terminal S harness.
- Remove starter motor mounting bolts.
- Remove starter motor upward from the vehicle.
INSTALLATION
Installation is in the reverse order of removal. Perform the following: Learning".
- Perform the "Throttle Valve Closed Position Learning" and "Accelerator Pedal Released Position Learning" when harness connector of ECM is disconnected. Refer to EC-140, "Work Procedure" and EC-139, "Work Procedure".
Service data and specifications (SDS)
Starter Motor
S connector circuit
Description
The starter motor magnetic switch is supplied with power when the ignition
switch is turned to the START position
while the selector lever is in the P (Park) or N (Neutral) position.
...
Other materials:
System description
Component Part Location
RH side of engine compartment
RH front of vehicle (view with front
bumper fascia removed)
LH front of vehicle (view with front
bumper fascia removed)
No.
Component
Description
1
IPDM E/R
Refer to PCS-5, "RELAY C ...
Sunshade motor assembly
Removal and Installation
REMOVAL
Remove the headlining. Refer to. INT-30, "Removal and Installation".
Disconnect the harness connector (A) from the sunshade motor
assembly (1).
Remove sunshade motor assembly screws (B).
Remove the sunshade motor assembl ...
P155D generator
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P155D
GENERATOR
(Generator)
ECM receives mechanical malfunction signal sent from generator.
ECM receives electrical malfunction ...
