Nissan Rogue Service Manual: Removal and installation
CHASSIS CONTROL MODULE
Exploded View
- Steering member
- Chassis control module
Front
Removal and Installation
CAUTION: When replacing chassis control module, configuration of chassis control module is required. Refer to DAS-205, "Work Procedure".
REMOVAL
NOTE: If the chassis control module is replaced, user registration information is erased, and all setting items for Nissan InTuition related parts are erased.
- Remove the glove box assembly. Refer to IP-23, "Removal and Installation".
- Release the pawl and remove the chassis control module.
CAUTION: Do not drop the chassis control module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: When replacing the chassis control module, perform the configuration of chassis control module.
Refer to DAS-205, "Work Procedure".
Symptom diagnosis
CHASSIS CONTROL
Active Engine Brake
NOTE:
For the operational conditions of Active Engine Brake, refer to
DAS-175, "System Description - Active
Engine Brake".
Perfor ...
Drive Mode System
SPORT MODE ...
Other materials:
Wiring diagram
TIRE PRESSURE MONITORING SYSTEM
Wiring Diagram
...
Brake pedal
Adjustment
BRAKE PEDAL HEIGHT
Remove instrument lower panel LH. Refer to IP-22, "Removal and
Installation".
Disconnect the harness connectors from the stop lamp switch and
brake pedal position switch.
Turn the stop lamp switch and brake pedal position switc ...
P0447 EVAP canister vent control valve
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0447
VENT CONTROL VALVE
(Evaporative emission system vent control
circuit open)
An improper voltage signal is sent to ECM through EVAP canister ...
