Nissan Rogue manuals

Nissan Rogue Service Manual: Removal and installation

Nissan Rogue Service Manual / Electrical & power control / Power Control System / IPDM E/R / Removal and installation

IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)

Exploded View

Exploded View

  1. IPDM E/R cover
  2. IPDM E/R
  3. IPDM E/R case
  4. IPDM E/R harness cover A
  5. IPDM E/R harness cover B

Front

Removal and Installation

CAUTION:  IPDM E/R integrated relays are not serviceable parts, do not remove from the IPDM E/R.

REMOVAL

  1.  Disconnect the negative battery terminal. Refer to PG-75, "Removal and Installation (Battery)".
  2.  Remove air duct (inlet). Refer to EM-24, "Exploded View".
  3. Release pawls on IPDM E/R cover (1) and remove.

    : Pawls

Removal

  1. Release pawls and remove IPDM E/R (1) from the IPDM E/R case (2).

    : Pawls

Removal

  1. Disconnect the harness connectors from IPDM E/R (1).

    CAUTION: Replace the IPDM E/R if it has been dropped or sustained an impact.

Removal

  1. Release the negative battery cable and harness clips from the IPDM E/R case.
  2. Release the pawls on the IPDM/ E/R harness covers A, B and remove from the IPDM E/R case.
  3. Remove the bolts from the IPDM E/R case.
  4. Remove the bolt (A) from the fusible link box (battery).

Removal

  1. Release the pawls on the fusible link box (battery) case (2) and remove from the IPDM E/R case (1).

    : Pawls

Removal

INSTALLATION

Installation is in the reverse order of removal.

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC CONSULT Display DTC Detection Condition Possible Cause ...

Power distribution system
...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

P0456 EVAP control system
DTC Description DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF. If ECM judges t ...

Tightening Torque Table (New Standard Included)
CAUTION:  The special parts are excluded.  The bolts/nuts in these tables have a strength (discrimination) number/symbol assigned to the head or the like. As to the relation between the strength grade in these tables and the strength (discrimination) number/symbol, refer to ...

© 2014-2022 Copyright www.nirogue.com