BCM (BODY CONTROL MODULE)
Removal and Installation
CAUTION: Before replacing the BCM, perform “READ CONFIGURATION” to save or print current vehicle specification.
Refer to BCS-60, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure".
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
COMBINATION SWITCH
Exploded View
Front
Removal and Installation
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
Periodic maintenance
REAR WHEEL HUB AND HOUSING
Inspection
INSPECTION
Make sure the conditions (looseness, back lash) of each component and
component conditions (wear, damage)
are normal.
WHEEL HUB AND BEARING INSPECTION
Move wheel hub and bearing in the axial direction by hand. Make
sure there is no ...
Radiator
RADIATOR CAP
RADIATOR CAP : Inspection
CHECKING RADIATOR CAP
Inspect the radiator cap.
Replace the cap if the metal plunger cannot be seen around the
edge of the black rubber gasket.
Replace the cap if deposits of waxy residue or other foreign
material are on th ...
Diagnosis and repair work flow
Work Flow
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTC ...