Nissan Rogue Service Manual: Removal and installation
HORN
Exploded View
- Horn (LOW)
- Horn (HIGH)
Removal and Installation
REMOVAL
Horn (LOW)
- Remove the front grille. Refer to EXT-23, "Removal and Installation".
- Disconnect the harness connectors from the horn (LOW).
NOTE: Before disconnecting the harness connectors, mark each for proper connection during installation.
- Remove bolt and the horn (LOW).
Horn (HIGH)
- Remove the engine side cover. Refer to EXT-28, "FENDER PROTECTOR : Exploded View".
- Partially remove the fender protector LH (front). Refer to EXT-28, "FENDER PROTECTOR : Exploded View".
- Disconnect the harness connectors from horn (HIGH).
NOTE: Before disconnecting the harness connectors, mark each for proper connection during installation.
- Remove nut and the horn (HIGH).
INSTALLATION
Installation is in the reverse order of removal.
Wiring diagram
HORN
Wiring Diagram
...
Other materials:
C1607, C1608 EPS control unit
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1607
EEPROM
When the memory (EEPROM) system malfunction is
detected in EPS control unit.
EPS control unit
C1608
CONTROL UNIT
When the in ...
Front regulator
Exploded View
Front door panel
Front door regulator
Front door power window motor
Front door glass run rear
Front door glass run front
Front door glass
Front door glass rubber run
Removal and Installation
REMOVAL
Remove the front door finisher. Refer to INT-15, ...
Precautions when starting and driving
WARNING
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentally injure themselves or
others through inadvertent operation of
the vehicle. Also, on h ...
