Nissan Rogue Service Manual: Removal and installation
- Washer tank
- Front and rear washer motor
- Washer fluid level switch
- Front washer nozzle and tube
- Front wiper arm
- Front wiper blade
- Front wiper drive assembly
- Front wiper motor
- Wiper and washer switch
- Rear wiper arm
- Rear wiper motor
- Rear washer nozzle and tube
Normal operating condition
Description
FRONT WIPER PROTECTION FUNCTION
IPDM E/R detects front wiper stop position by a front wiper stop position
signal.
When a front wiper stop position signal is in the conditions listed ...
Washer tank
Exploded View
Cap
Washer tank
Washer tank inlet
Clip
Removal and Installation
REMOVAL
Drain washer fluid.
Using a suitable tool release washer tank in ...
Other materials:
P0441 EVAP control system
DTC Description
DTC DETECTION LOGIC
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge volume is related to air intake volume. Under normal purge conditions
(non-closed throttle), the EVAP
canister purge volume control solenoi ...
Sunshade
Removal and Installation
REMOVAL
Remove the moonroof unit assembly. Refer to RF-53, "Removal and
Installation".
Place the moonroof unit assembly (1) on a flat surface upside
down and remove sunshade (2) screws (A).
Manually move sunshade motor (1) using suitable tool (2 ...
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following
conditions:
Each time electric throttle control actuator or ECM is replaced.
Idle spee ...
