Nissan Rogue manuals

Nissan Rogue Service Manual: Rear suspension ARM

Exploded View

Exploded View

  1. Rear suspension arm
  2. Rubber washer (LH/RH)
  3. Rear suspension arm bracket
  4. Rear suspension arm stay

Front

Removal and Installation

REMOVAL

  1.  Remove the wheel hub and bearing. Refer to RAX-16, "Removal and Installation".
  2. Remove the coil spring. RSU-10, "Removal and Installation - AWD".
  3.  Separate the brake tube and hose from the rear suspension arm. BR-24, "REAR : Exploded View".
  4.  Remove the nut, bolt, rubber washer (LH/RH), and rear suspension arm.
  5.  Inspect the components. Refer to RSU-14, "Inspection".

INSTALLATION

Installation is in the reverse order of removal.

Inspection

INSPECTION AFTER REMOVAL

Visual Inspection

Check rear suspension arm and bushing for deformation, cracks or damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION

  1.  Adjust parking brake operation (stroke). Refer to PB-4, "Inspection and Adjustment".
  2.  Check wheel alignment. Refer to RSU-6, "Inspection".
Rear shock absorber
Exploded View Rear suspension member Upper seat Coil spring Lower seat Rubber washer (LH/RH) Rear suspension arm Rear shock absorber Front Removal and Installation REMOVAL ...

Lower link
Exploded View Rear suspension member Lower link Lower link deflector Rubber washer (LH/RH) Rear suspension arm Front Removal and Installation REMOVAL  Remove wheel a ...

Other materials:

Basic inspection
COMPONENT INSPECTION Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and t ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools Tool name ...

P0643 sensor power supply
Description ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the short-circuited ...

© 2014-2022 Copyright www.nirogue.com