Nissan Rogue Service Manual: Rear stabilizer
Exploded View
- Rear stabilizer bar
- Connecting rod (RH)
- Rear stabilizer bar bushing
- Rear stabilizer bar clamp
- Connecting rod (LH)
Front
Removal and Installation
REMOVAL
- Disconnect rear stabilizer links from rear stabilizer bar.
- Remove nuts on rear stabilizer clamp.
- Remove rear stabilizer bar from rear suspension member
- Remove rear stabilizer bushings from rear stabilizer bar (if necessary).
- Perform the inspection after removal. Refer to RSU-21, "Inspection".
INSTALLATION
Installation is in the reverse order of removal.
Inspection
INSPECTION AFTER REMOVAL
Check rear stabilizer bar, rear stabilizer link, rear stabilizer bushing and rear stabilizer clamp for deformation, cracks or damage. Replace it if necessary.
Upper link
Exploded View
Rear suspension member
Upper link
Rubber washer (LH/RH)
Rear suspension arm
Front
Removal and Installation
REMOVAL
Remove wheel and tir ...
Unit removal and installationEMBER
REAR SUSPENSION M
Exploded View
Rear suspension member
Suspension member stay
(RH)
Suspension member stay (LH)
Bound bumper
Front
Removal and Installation - F ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Removal and installation
REAR PROPELLER SHAFT
Exploded View
Center bearing mounting bracket
(upper)
Clip
Propeller shaft assembly
Center bearing mounting bracket
(lower)
: Vehicle front
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
Shif ...
P0182, P0183 FTT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0182
FTT SEN/CIRCUIT
(Fuel temperature sensor ″A″ circuit low)
An excessively low voltage from the sensor is sent to ECM.
P01 ...
