Nissan Rogue manuals

Nissan Rogue Service Manual: Primary speed sensor

Exploded View

Exploded View

  1. Transaxle assembly
  2. O-ring
  3. Primary speed sensor

: Always replace after every disassembly.
: N·m (kg-m, in-lb)
: Apply CVT fluid

Removal and Installation

REMOVAL

  1.  Remove the engine undercover. Refer to EXT-37, "ENGINE UNDER COVER : Removal and Installation".
  2.  Disconnect the primary speed harness connector.
  3.  Remove the primary speed sensor bolt and remove the primary speed sensor.
  4.  Remove the O-ring from the primary speed sensor.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM-190, "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM-192, "Adjustment".

Input speed sensor
Exploded View Input speed sensor O-ring Transaxle assembly : Always replace after every disassembly. : N·m (kg-m, in-lb) : Apply CVT fluid Removal and Installation REMOVAL ...

Output speed sensor
Exploded View Transaxle assembly Output speed sensor O-ring Always replace after every disassembly. : N·m (kg-m, in-lb) : Apply CVT fluid Removal and Installation REMOVAL ...

Other materials:

Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to the vehicle. The following are general precautions which should be closely observed. WARNING  Park the vehicle on a level surface, a ...

Bluetooth® Hands-Free Phone System with Navigation System (if so equipped)
WARNING  Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation.  If you are unable to devote full attention to vehicl ...

ABC warning lamp
Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for 1 second after ignition switch is turned ON. CAUTION: Never start the engine. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to BRC-1 ...

© 2014-2024 Copyright www.nirogue.com