Nissan Rogue Service Manual: Preparation

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Door & Lock / Without intelligent key system / Preparation

Special Service Tool

The actual shapes of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name		Tool number (TechMate No.) Tool name
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit		Repairing the cause of noise
— (J-43241) Remote Keyless Entry Tester		Used to test keyfobs
— (J-50190) Signal Tech II		Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display
KV48105501 (J-45295-A) Transmitter Activation Tool		Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Power Tool		Loosening nuts, screws and bolts

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description

COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Re ...

Other materials:

Tire pressure sensor
Exploded View Tire pressure sensor O-ring Valve stem nut Valve core Valve cap Valve stem assembly : Parts that are replaced as a set when the tire is replaced. Removal and Installation REMOVAL Remove wheel and tire using power tool. Remove v ...

USB (Universal Serial Bus) Connection Port (models without Navigation System) (if so equipped)
USB (Universal Serial Bus) Connection Port (models without Navigation System) Connecting a device to the USB Connection Port WARNINGDo not connect, disconnect, or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your ...

P1574 ASCD vehicle speed sensor
Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...