Nissan Rogue Service Manual: Preparation

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Door & Lock / With intelligent key system / Preparation

Special Service Tool

The actual shapes of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name		Description
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit		Repairing the cause of noise
— (J-43241) Remote Keyless Entry Tester		Used to test keyfobs
— (J-50190) Signal Tech II		Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display
KV48105501 (J-45295-A) Transmitter Activation Tool		Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Power Tool		Loosening nuts, screws and bolts

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description

COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Re ...

Other materials:

The ambient temperature display is incorrect
Description The displayed outside air temperature is higher than the actual temperature. The displayed outside air temperature is lower than the actual temperature. Outside air temperature is not indicated. Diagnosis Procedure 1.CHECK AMBIENT SENSOR SIGNAL CIRCUIT Chec ...

Additional service when replacing ECM
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-136, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...

Meter system
Wiring diagram ...