Nissan Rogue Service Manual: Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".
1. CHECK FUSE
Check that the following fuse is not blown.
| Terminal No. | Signal name | Fuse No. |
| 161 | BCM power supply | 7 (10A) |
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 2.
2. CHECK POWER SUPPLY CIRCUIT
- Disconnect BCM connector M20.
- Check voltage between BCM connector M20 and ground.
| BCM | Ground | Voltage (Approx.) | |
| Connector | Terminal | ||
| M20 | 161 | — | Battery voltage |
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connectors.
3. CHECK GROUND CIRCUIT
Check continuity between BCM connector M20 and ground.
| BCM | Ground | Continuity | |
| Connector | Terminal | ||
| M20 | 170 | — | Yes |
| 171 | |||
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace harness or connectors.
WITHOUT INTELLIGENT KEY SYSTEM
WITHOUT INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-110, "Wiring Diagram".
1. CHECK FUSE
Check that the following fuse is not blown.
| Terminal No. | Signal name | Fuse No. |
| 161 | BCM power supply | 7 (10A) |
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 2.
2. CHECK POWER SUPPLY CIRCUIT
- Disconnect BCM connector M20.
- Check voltage between BCM connector M20 and ground.
| BCM | Ground | Voltage (Approx.) | |
| Connector | Terminal | ||
| M20 | 161 | — | Battery voltage |
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connectors.
3. CHECK GROUND CIRCUIT
Check continuity between BCM connector M20 and ground.
| BCM | Ground | Continuity | |
| Connector | Terminal | ||
| M20 | 170 | — | Yes |
| 171 | |||
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace harness or connectors.
Low tire pressure warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after
illuminating for approximately 1 second,
...
Other materials:
Accelerator pedal released position learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...
Fuel gauge
Principle
The current fill level of the fuel tank is displayed.
General information
Vehicle inclination may cause the display to vary.
Additional information:
Refueling.
Display
An arrow next to the fuel pump
symbol indicates the vehicle side
on which the fuel filler flap is located.
The current r ...
Approach warning
Approach warning
NOTE:
The warning chime may sound and the FCW
indicator may blink when the distance sensor
detects vehicles in other lanes A or
objects on the side of the road A . This may
cause the FCW system to operate inappropriately.
The distance sensor may detect
these objects wh ...
