Nissan Rogue manuals

Nissan Rogue Owners Manual: Power outlets

Instrument Panel
Instrument Panel

12V OUTLETS

The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 volt, 120W (10A) maximum.

The front and center console power outlets are powered only when the ignition switch is in the ACC (if so equipped) or ON position.

Center Console
Center Console

CAUTION
  •  The outlet and plug may be hot during or immediately after use.
  •  Only certain power outlets are designed for use with a cigarette lighter unit. Do not use any other power outlet for an accessory lighter. See your NISSAN dealer for additional information.
  •  Do not use with accessories that exceed a 12 volt, 120W (10A) power draw.
  •  Do not use double adapters or more than one electrical accessory.
  •  Use power outlets with the engine running to avoid discharging the vehicle battery.
  •  Avoid using power outlets when the air conditioner, headlights or rear window defroster is on.
  •  Before inserting or disconnecting a plug, be sure the electrical accessory being used is turned OFF.
  • Push the plug in as far as it will go. If good contact is not made, the plug may overheat or the internal temperature fuse may open.
  •  When not in use, be sure to close the cap. Do not allow water or any other liquid to contact the outlet.

Cargo Area
Cargo Area

Warning systems switch (if so equipped)
Warning systems switch (if so equipped) The warning systems switch is used to turn on and off the warning systems (Lane Departure Warning (LDW), Forward Collision Warning (FCW) and Blind SpotW ...

Storage
...

Other materials:

Difference between predicted and actual distances
Backing up on a steep uphill When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance. For example, the display shows 3 ft (1.0 m) to the place A , but the actual 3 ft (1.0 m) distance on the hill is the p ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2. 2.CHECK DTC  Ch ...

Ecu diagnosis information
ECM Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Numerical values in the following table are reference values. These v ...

В© 2014-2022 Copyright www.nirogue.com