Nissan Rogue Service Manual: Plug

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Removal and installation / Plug

Description

Replace the O-ring if oil leakage or exudes from the plug.

Exploded View

Exploded View

Transaxle assembly
O-ring
Plug

: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: Apply CVT fluid

Removal and Installation

REMOVAL

Partially remove front fender protector (LH). Refer to EXT-28, "FENDER PROTECTOR : Exploded View".
Remove the plug and O-ring.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not reuse O-ring.
Apply CVT fluid to O-ring.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM-190, "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM-192, "Adjustment".

CVT oil warmer

Exploded View Transaxle assembly CVT oil warmer : N·m (kg-m, in-lb) Removal and Installation REMOVAL WARNING: Do not remove the radiator cap when the engine is hot. Serious burns co ...

Unit removal and installation

TRANSAXLE ASSEMBLY Exploded View Transaxle assembly O-ring CVT fluid charging pipe CVT fluid charging pipe cap For the tightening torque, refer to TM-220, "Removal an ...

Other materials:

P0500 VSS
Description ECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the other is from TCM. DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms ...

Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic M Description Ecu Identification The BCM part number is displayed. Self Diagnostic Res ...

B14XX air bag diagnosis sensor unit
Description DTC B1XXX AIR BAG DIAGNOSIS SENSOR UNIT The air bag diagnosis sensor unit will run self diagnostics when the ignition switch is turned ON. It has the potential to set many diagnostic trouble codes which will conform to the B1XXX format, but will not match any other SRS diagnostic ...