Nissan Rogue Service Manual: Periodic maintenance
FRONT WHEEL HUB AND KNUCKLE
Inspection
- Move the wheel hub and bearing in an axial direction by hand to verify that looseness of wheel hub and bearing exists. If any looseness exists, replace the wheel hub and bearing.
Axial end play : Refer to FAX-32, "Wheel Bearing".
- Rotate wheel hub and bearing to verify if unusual noises or other irregular conditions exist. If any irregular conditions exist, replace the wheel hub and bearing.
FRONT DRIVE SHAFT
Inspection
Check drive shaft mounting point and joint for looseness and other damage.
- Check boot for cracks and other damage.
CAUTION: Replace entire drive shaft assembly when noise or vibration occurs from drive shaft.
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicable ...
Removal and installation
FRONT WHEEL HUB
Exploded View
Wheel hub and bearing
Cotter pin
Nut retainer
Wheel hub lock nut
Hub bolt
Splash guard
Steering knuckle
Removal and In ...
Other materials:
System limits - Active Cruise Control with
Stop&Go function ACC
System limits
System limits of the sensors
Additional information:
Cameras
Radar sensors
Detection range
The detection capability of the system and the
automatic braking performance are limited.
Two-wheeled vehicles for instance might not be
detected.
Deceleration
The system does not decelerate ...
Safety belts
General information
The vehicle is fitted with five or seven safety
belts to ensure occupant safety. However, they
can only unfold their protective effect when adjusted
correctly.
Always make sure that safety belts are being
worn by the occupants before driving off. The
airbags supplement the safety ...
P2100, P2103 throttle control motor relay
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P2100
ETC MOT PWR-B1
(Throttle actuator ″A″ control motor circuit/
open)
ECM detects a voltage of power source for throttle control ...
