Nissan Rogue manuals

Nissan Rogue Service Manual: Periodic maintenance

FRONT WHEEL HUB AND KNUCKLE

Inspection

Axial end play : Refer to FAX-32, "Wheel Bearing".

FRONT DRIVE SHAFT

Inspection

Check the following items and replace parts as necessary:

CAUTION: Replace entire drive shaft when noise or vibration occurs from drive shaft.

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOO NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Removal and installation
FRONT WHEEL HUB Exploded View Disc brake rotor  Nut retainer Cotter pin Wheel stud  Steering knuckle Splash guard  Wheel hub and bearing Wheel hub lock n ...

Other materials:

P0139 HO2S2
DTC Description DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sens ...

VDC off indicator lamp
Component Function Check 1.CHECK VDC OFF INDICATOR LAMP FUNCTION (1) Check that VDC OFF indicator lamp in combination meter turns ON for 1 second after ignition switch is turned ON. CAUTION: Never start the engine. Is the inspection result normal? YES >> GO TO 2. NO >> Proc ...

P0112, P0113 IAT sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0112 IAT SEN/CIRCUIT- B1 (Intake air temperature sensor 1 circuit low bank 1) An excessively low voltage from the intake air temperature sensor ...

© 2014-2024 Copyright www.nirogue.com