Nissan Rogue manuals

Nissan Rogue Service Manual: Periodic maintenance

REAR DIFFERENTIAL GEAR OIL

Inspection

OIL LEAKS

Make sure that oil is not leaking from final drive assembly or around it.

OIL LEVEL

Inspection

Draining

  1. Stop engine.
  2.  Remove drain plug (1) and drain gear oil.
  3.  Set a new gasket on drain plug and install it to final drive assembly and tighten to the specified torque. Refer to DLN-124, "Exploded View".

CAUTION: Do not reuse gasket.

Draining

Refilling

  1. Remove filler plug (1). Fill with new gear oil until oil level reaches the specified level near filler plug hole.

Refilling

Oil grade and viscosity : Refer to MA-11, "Fluids and Lubricants".

Oil capacity : Refer to DLN-141, "General Specifications".

  1. After refilling oil, check oil level. Set a new gasket to filler plug, then install it to final drive assembly. Refer to DLN-124, "Exploded View".

CAUTION: Do not reuse gasket.

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicabl ...

Removal and installation
DRIVE PINION OIL SEAL Exploded View Rear final drive assembly Drive pinion oil seal Electric controlled coupling assembly Oil seal lip Always replace after every disassembly. : ...

Other materials:

P0520 EOP sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0520 EOP SENSOR/SWITCH (Engine oil pressure sensor/switch circuit) Signal voltage from the EOP sensor remains at more than 5.02 V / less than ...

Side air bag (satellite) sensor
Exploded View Front door satellite sensor Front side air bag satellite sensor Rear side satellite sensor Satellite sensor harness connector  Bolt  Nut  Pawl Front NOTE: RH side shown, LH side similar. Removal and Installation WARNING:  Bef ...

Over fender
FRONT OVER FENDER FRONT OVER FENDER : Exploded View Front fender protector  Front fender  Front over fender molding Clip FRONT OVER FENDER : Removal and Installation REMOVAL Remove front and rear screw (A). 1: Front over fender 2: Sill molding : Front ...

© 2014-2024 Copyright www.nirogue.com