Nissan Rogue manuals

Nissan Rogue Service Manual: Parking brake switch signal circuit

Description

Transmits the parking brake switch signal to the combination meter.

Component Function Check

1.COMBINATION METER INPUT SIGNAL

  1.  Start engine.
  2.  Check "PKB SW" in "Data Monitor" while applying and releasing the parking brake.

Combination meter input signal

Is the inspection result normal? YES >> Inspection End.

NO >> Refer to MWI-64, "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram".

1.CHECK PARKING BRAKE SWITCH CIRCUIT

  1.  Disconnect combination meter harness connector M76 and parking brake switch harness connector E52.
  2.  Check continuity between combination meter harness connector M76 terminal 26 and parking brake switch harness connector E52 terminal 1.

Check parking brake switch circuit

  1. Check continuity between combination meter harness connector M76 terminal 26 and ground.

Check parking brake switch circuit

Is the inspection result normal? YES >> Inspection End.

NO >> Repair or replace harness or connector.

Component Inspection

1.CHECK PARKING BRAKE SWITCH

Check continuity between parking brake switch terminal 1 and switch case ground.

Check parking brake switch

Is the inspection result normal? YES >> Inspection End.

NO >> Replace parking brake switch. Refer to PB-7, "Exploded View".

Fuel level sensor signal circuit
Component Function Check 1.COMBINATION METER INPUT SIGNAL  Select "METER/M&A" on "CONSULT".  Using "FUEL METER" of "Data Monitor", compare ...

Ambient sensor signal circuit
Description It detects outside air temperature and converts it into a resistance value which is then input into the combination meter. Diagnosis Procedure Regarding Wiring Diagram information, r ...

Other materials:

CVT control system
Wiring Diagram ...

Push-button ignition switch positions
LOCK (Normal parking position): The ignition switch can only be locked in this position. The ignition switch will lock when any door is opened or closed with the ignition switched off. ON (Normal operating position): This position turns on the ignition system and electrical accessories. ...

Control cable
Exploded View Shift selector Control cable Retainer grommet  Lock plate Bracket Manual lever Transaxle assembly Front Removal and Installation CAUTION: Always apply the parking brake before performing removal and installation. REMOVAL  Apply the parking ...

В© 2014-2022 Copyright www.nirogue.com