Nissan Rogue Service Manual: Parking brake rear cable

Nissan Rogue Service Manual / Brakes / Parking Brake System / Removal and installation / Parking brake rear cable

Removal and Installation

REMOVAL

Remove the center console assembly. Refer to IP-18, "Removal and Installation".
Remove shift selector. Refer to TM-194, "Removal and Installation".
Remove the bolts from the parking brake front cable mount. Refer to PB-7, "Exploded View".
Loosen the adjusting nut. Refer to PB-7, "Exploded View".
NOTE: It is not necessary to remove the parking brake front cable.
Pull equalizer (A) of the parking brake front cable (1) in a rearward direction and then push upward to separate each parking brake rear cable (2) from the parking brake front cable (1).
CAUTION: To prevent damage to the parts, do not bend the parking brake cables.

Removal

Press the pawl (1) to remove each parking brake rear cable from the vehicle.

Removal

Remove the parking brake shoes, and separate the parking brake rear cable from the toggle lever. Refer to PB-11, "Removal and Installation".

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Do not reuse the adjusting nut if the nut is removed.

Inspect and adjust the parking brake pedal. Refer to PB-4, "Inspection and Adjustment".
Inspect and adjust the parking brake shoes. Refer to PB-6, "Inspection and Adjustment".

Parking brake front cable

Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP-22, "Removal and Installation". Remove driver seat (LH). Refer to SE-32, "DRIVER ...

Parking brake switch

Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP-22, "Removal and Installation". Disconnect the harness connector from the parking bra ...

Other materials:

The meter control switch is inoperative
Description The meter control switches are inoperative when pressed. Diagnosis Procedure 1.CHECK METER CONTROL SWITCH SIGNAL Check the meter control switch signal. Refer to MWI-67, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair ...

Fuse inspection
How To Check If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. Use fuse of specified rating. Never use fuse of more than specified rating. Do not partially install fuse; always insert it into fuse holder properly. Remove fus ...

Rear washer nozzle and tube
Exploded View Rear washer tube Rear grommet Clip Removal and Installation - Rear Washer Nozzle REMOVAL Remove rear access panel. Refer to INT-38, "Exploded View". Release pawls and remove rear washer nozzle (1). : Pawl INSTALLATION Installation in the ...