Nissan Rogue manuals

Nissan Rogue Service Manual: Parking brake front cable

Removal and Installation

REMOVAL

  1.  Remove the instrument lower panel LH. Refer to IP-22, "Removal and Installation".
  2.  Remove driver seat (LH). Refer to SE-32, "DRIVER SIDE : Removal and Installation"
  3.  Remove the center console. Refer to IP-18, "Removal and Installation".
  4.  Remove the parking brake control. Refer to PB-7, "Removal and Installation"
  5.  Remove front door welts (LH). Refer to INT-23, "BODY SIDE WELT : Removal and Installation - Front Door Welt".
  6.  Remove dash side finisher (LH). Refer to INT-24, "DASH SIDE FINISHER : Removal and Installation".
  7.  Remove shift selector. Refer to TM-194, "Removal and Installation".
  8.  Remove the front floor connecting ducts (LH/RH). Refer to VTL-10, "FRONT FLOOR DUCT : Removal and Installation - Front Floor Connecting Duct".
  9.  Remove the front floor duct. Refer to VTL-11, "FRONT FLOOR DUCT : Removal and Installation - Front Floor Duct"
  10.  Remove the rear center ventilator duct. Refer to VTL-11, "REAR CENTER VENTILATOR DUCT : Removal and Installation".
  11.  Release clips (A) using a suitable tool and remove steering joint floor cover (1).

Removal

  1. Place front floor trim aside and remove the front floor spacer. Refer to INT-26, "Exploded View".
  2.  Remove the bolts from the parking brake front cable mount. Refer to PB-7, "Exploded View".
  3.  Pull equalizer (A) of the parking brake front cable (1) in a rearward direction and then push upward to separate each parking brake rear cable (2) from the parking brake front cable (1).

    CAUTION: To prevent damage to the parts, do not bend the parking brake cables.

Removal

  1. Remove the parking brake front cable.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Do not reuse the adjusting nut.

Parking brake control
Exploded View Parking brake rear cable (RH) Parking brake rear cable (LH) Parking brake front cable  Parking brake control Adjusting nut Parking brake switch Removal and ...

Parking brake rear cable
Removal and Installation REMOVAL  Remove the center console assembly. Refer to IP-18, "Removal and Installation".  Remove shift selector. Refer to TM-194, "Removal a ...

Other materials:

Seatback pockets
Seatback pockets There is a pocket located on the back of the driver and passenger seats. These pockets can be used to store maps. WARNINGTo ensure proper operation of the passenger’s advanced air bag system, please observe the following items:  Do not allow a pas ...

Break-in schedule
CAUTIONDuring the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine ...

Luggage room lamp circuit
Description Controls the luggage room lamp (ground side) to turn the luggage room lamp ON and OFF. Diagnosis Procedure CAUTION: Before performing the diagnosis, check that the following is normal.  Interior room lamp power supply  Luggage room lamp bulb 1.CHECK LUGGAGE ROOM ...

© 2014-2024 Copyright www.nirogue.com