Nissan Rogue Service Manual: P155D generator

Nissan Rogue Service Manual / Engine / Engine Control System / DTC/Circuit diagnosis / P155D generator

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition
P155D	GENERATOR (Generator)	ECM receives mechanical malfunction signal sent from generator. ECM receives electrical malfunction signal sent from generator.

POSSIBLE CAUSE

Generator

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted. always perform the following procedure before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start the engine and let it idle at least 10 seconds.
Check DTC.

Is DTC detected? YES >> Proceed to EC-175, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CHARGING SYSTEM

Perform trouble diagnosis for charging system. Refer to EC-165, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-41, "Intermittent Incident".

Is the inspection result normal? YES >> Replace generator. Refer to CHG-20, "Removal and Installation".

NO >> Repair or replace error-detected parts.

P1226 TP sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1226 CTP LEARNING-B1 (CTP LEARNING-B1) Closed ...

1564 ASCD steering switch

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1564 ASCD SW (ASCD switch) An excessi ...

Other materials:

VIN registration
Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M). Work Procedure 1.CHECK VIN Check the VIN of the vehicle and note it. ...

Flat towing for front wheel drive vehicle (if so equipped)
Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. CAUTION Failure to follow these guidelines can result in severe transmission dama ...

Battery
Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. Make certain the terminal connections are clean and securely tightened. If the vehicle is not to be used for 30 days or longer, disconnect the negative (-) battery termina ...