Nissan Rogue Service Manual: P0963 pressure control solenoid A

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Dtc/circuit diagnosis / P0963 pressure control solenoid A

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0963	PC SOLENOID A (Pressure Control Solenoid A Control Circuit High)	When all of the following conditions are satisfied and this state is maintained for 0.2 seconds: TCM power supply voltage: More than 11 V P0962 is not detected TCM judges that solenoid valve circuit is open.

POSSIBLE CAUSE

Harness or connector (Line pressure solenoid valve circuit is open or shorted to power supply)
Line pressure solenoid valve

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine and wait for 5 seconds or more.
Check the first trip DTC.

Is “P0963” detected? YES >> Go to TM-159, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

Turn ignition switch OFF.
Disconnect TCM connector and CVT unit connector.
Check continuity between TCM harness connector terminal and ground.

Check circuit between TCM and CVT unit

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace damaged parts.

2.CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND

Check continuity between CVT unit harness connector terminal and ground.

Check circuit between CVT unit and ground

Is the inspection result normal? YES >> INSPECTION END

NO >> There is malfunction of line pressure solenoid valve. Replace transaxle assembly. Refer to TM- 220, "Removal and Installation".

P0962 pressure control solenoid A

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0962 PC SOLENOID A (Pressure Control Solenoid A Contr ...

P0965 pressure control solenoid B

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0965 PC SOLENOID B (Pressure Control Solenoid B Contr ...

Other materials:

Third row seat
Exploded View Seatback board (RH) Seatback trim (RH) Seatback pad (RH) Seat cushion trim (RH) Seat cushion pad (RH) Seat cushion silencer (LH/RH) Seat hinge finisher (RH) Gas stay Bolt cover (RH) Seat belt buckle (RH) Seat belt buckle (LH) Bolt ...

Retained power operation does not operate properly
Diagnosis Procedure 1.CHECK FRONT DOOR SWITCH Check (LH and RH) front door switches. Refer to DLK-24, "Front Door Switch". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CONFIRM THE OPERATION Confirm the operat ...

Sunglasses holder
Sunglasses holder To open the sunglasses holder 1 , push and release. Only store one pair of sunglasses in the holder. WARNINGKeep the sunglasses holder closed while driving to prevent an accident. CAUTION Do not use for anything other than sung ...