Nissan Rogue Service Manual: P0890 TCM
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition |
| P0890 | TCM (Transmission Control Module Power Relay Sense Circuit Low) | When all of the following conditions are satisfied and this state is
maintained
for 0.2 seconds:
|
POSSIBLE CAUSE
- Harness or connector [TCM power supply (back-up) circuit is open or shorted]
- TCM
FAIL-SAFE
- Selector shock is large
- Start is slow
- Acceleration is slow
- Lock-up is not performed
- Vehicle speed is not increased
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
- Start the engine and wait for 5 seconds or more.
- Check the DTC.
Is “P0890” detected? YES >> Go to TM-155, "Diagnosis Procedure".
NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".
NO-2 >> Confirmation after repair: INSPECTION END
Diagnosis Procedure
1.CHECK TCM POWER SUPPLY (BACK-UP) CIRCUIT
- Turn ignition switch OFF.
- Disconnect TCM connector.
- Check voltage between TCM harness connector terminals and ground.
Is the inspection result normal? YES >> Replace TCM. Refer to TM-202, "Removal and Installation".
NO >> GO TO 2.
2.DETECT MALFUNCTIONING ITEMS
Check the following items:
- Open circuit or short circuit in harness between battery positive terminal and TCM connector terminals 45, and 46.
- 10A fuse (No.59, located in the fuse and fusible link block). Refer to PG-65, "Terminal Arrangement".
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace malfunctioning parts.
P0863 TCM communication
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0863
CONTROL UNIT (CAN)
(TCM Communication Circuit)
...
P0962 pressure control solenoid A
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0962
PC SOLENOID A
(Pressure Control Solenoid A Contr ...
Other materials:
Map lamp assembly
Exploded View
Map lamp assembly bracket
(with moonroof)
Headlining
Map lamp assembly
Map lamp assembly bracket
(without moonroof)
Dual magnet
Metal clip
Pawl
Removal and Installation
REMOVAL
Lower front edge of map lamp assembly (1) down from the
hea ...
Operating tips
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is
not a malfunction. After the coolant temperature
warms up, air flow from the foot outlets
will operate normally.
...
Front seat
DRIVER SIDE
DRIVER SIDE : Exploded View
POWER SEAT
Headrest
Seatback support
Seatback board
Seatback heater (if equipped)
Seatback trim
Seatback pad
Seat cushion outer finisher (RH)
Seat cushion rear finisher
(RH)
Seat cushion inner fini ...
