Nissan Rogue manuals

Nissan Rogue Service Manual: P0841 transmission fluid pressure SEN/SW A

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A” Circuit Range/Performance) When all of the following conditions are satisfied and this state is maintained for 5 seconds:
  •  TCM power supply voltage: More than 11 V
  •  DTC other than the applicable DTC is not detected.
  •  Primary pulley speed: 300 rpm or more
  •  Secondary pulley speed: 250 rpm or more
  •  Target speed for shifting: Less than 0.1 seconds
  •  Primary pulley pressure is outside the specified value.

POSSIBLE CAUSE

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1.  Start the engine.
  2.  Drive the vehicle.
  3.  Maintain the following condition for 10 seconds or more.

Selector lever : “D” position
Vehicle speed : Constant speed of 40 km/h (25 MPH)

CAUTION: Also keep the accelerator pedal position constant.

  1.  Stop the vehicle.
  2.  Check the first trip DTC.

Is “P0841” detected? YES >> Go to TM-145, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.REPLACE TRANSAXLE ASSEMBLY

Replace transaxle assembly. Refer to TM-220, "Removal and Installation".

>> WORK END

P0779 pressure control solenoid B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0779 Pressure control solenoid B Inte When all of the ...

P0847 transmission fluid pressure SEN/SW B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0847 FLUID PRESS SEN/SW B (Transmission Fluid Pressur ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system s ...

Unit removal and installation
ENGINE ASSEMBLY Exploded view Engine mounting insulator (RH)  Upper torque rod (RH) Engine mounting bracket (RH)  Lower torque rod  Torque rod bracket  Engine mounting insulator (LH) Removal and installation (FWD) WARNING:  Situate the vehicl ...

SRS air bag warning lamp does not turn off
AIR BAG Warning Lamp Does Not Turn Off 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. Are any air bag modules or seat belt pre-tensioners deployed? YES >> Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS i ...

© 2014-2025 Copyright www.nirogue.com