DTC Description
DTC DETECTION LOGIC
DTC | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition |
P0717 | INPUT SPEED SENSOR A (Input/Turbine Speed Sensor “A” Circuit No Signal) | When 1 is satisfied and any of 2, 3 or 4 is satisfied:
|
POSSIBLE CAUSE
FAIL-SAFE
DTC CONFIRMATION PROCEDURE
CAUTION: Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT
Selector lever : “D” position
Engine speed : 1,200 rpm or more
Vehicle speed : 40 km/h (25 MPH) or more
Is “P0717” detected? YES >> Go to TM-129, "Diagnosis Procedure".
NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".
NO-2 >> Confirmation after repair: INSPECTION END
Diagnosis Procedure
1.CHECK INPUT SPEED SENSOR POWER CIRCUIT
Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 6.
2.CHECK INPUT SPEED SENSOR GROUND CIRCUIT
Check continuity between input speed sensor harness connector terminal and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace malfunctioning parts.
3.CHECK CIRCUIT BETWEEN INPUT SPEED SENSOR AND TCM (PART 1)
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace malfunctioning parts.
4.CHECK CIRCUIT BETWEEN INPUT SPEED SENSOR AND TCM (PART 2)
Check continuity between input speed sensor harness connector terminal and ground.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace malfunctioning parts.
5.CHECK TCM INPUT SIGNALS
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace input speed sensor. Refer to TM-207, "Removal and Installation".
6.CHECK CIRCUIT BETWEEN IPDM E/R AND INPUT SPEED SENSOR
Is the check result normal? YES >> GO TO 7.
NO >> Repair or replace malfunctioning parts.
7.DETECT MALFUNCTIONING ITEMS
Check the following items:
Is the check result normal? YES >> INSPECTION END
NO >> Repair or replace malfunctioning parts.
System description
COMPONENT PARTS
POWER DOOR LOCK SYSTEM
POWER DOOR LOCK SYSTEM : Component Parts Location
No
Component
Function
1
BCM
Controls the door lock system.
Refer to BCS-7, "BODY CONTROL SYSTEM : Component Parts Location" for
detailed
install ...
Wiring diagram
DRIVER ASSISTANCE SYSTEMS
Wiring Diagram
...
System description
DESCRIPTION
Engine Lubrication System
Camshaft (INT)
Chain tensioner
Main gallery
Oil pan
Oil cooler
Balancer unit
Oil pan oil gallery
Oil filter (with relief valve)
Oil Strainer
Oil pump
Timing chain and balancer unit timing
chain ...