Nissan Rogue manuals

Nissan Rogue Service Manual: P060A ECM

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition
P060A CONTROL MODULE (Internal control module monitoring processor performance) ECM internal monitoring processor is malfunctioning.

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

  1.  Turn ignition switch OFF and wait at least 10 seconds.
  2.  Turn ignition switch ON.
  3.  Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Start engine and wait at least 10 seconds.
  2.  Turn ignition switch OFF and wait at least 10 seconds.
  3.  Repeat step 1 and 2 for 5 times.
  4.  Turn ignition switch ON.
  5.  Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-377, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Turn ignition switch ON.
  2.  Erase DTC.
  3.  Perform DTC confirmation procedure. Refer to EC-377, "DTC Description".

Is the 1st trip DTC P060A displayed again? YES >> Replace ECM. Refer to EC-499, "Removal and Installation".

NO >> INSPECTION END

P0607 ECM
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0607 ECM (Control module performance) ECM inte ...

P060B ECM
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P060B CONTROL MODULE (Internal control module A/D ...

Other materials:

Heated seats (if so equipped)
The front seats are warmed by built-in heaters.  Start the engine.  Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate. The heater is controlled by a thermostat, automatically turning the heater on and off. The in ...

Sport program M/S - Steptronic transmission
Sport program M/S Principle The shifting points and shifting times in the Sport program are designed for sportier handling. The transmission, for instance shifts up later and the shifting times are shorter. Activating the Sport program Press the selector lever to the left from selector lever posit ...

Brakes
If the brakes do not operate properly, have the brakes checked by a NISSAN dealer. Self-adjusting brakes Your vehicle is equipped with self-adjusting brakes. The front and rear disc-type brakes self-adjust every time the brake pedal is applied. WARNINGSee a NISSAN dealer for a brake ...

В© 2014-2022 Copyright www.nirogue.com