Nissan Rogue manuals

Nissan Rogue Service Manual: P0604 ECM

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition
P0604 ECM [Internal control module random access memory (RAM) error] Malfunction in the internal RAM of ECM.

POSSIBLE CAUSE

ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

  1.  Turn ignition switch OFF and wait at least 10 seconds.
  2.  Turn ignition switch ON.
  3.  Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Turn ignition switch ON (engine stopped) and wait least 20 minutes.

    CAUTION: Never start engine during this procedure.

  2.  Turn ignition switch OFF and wait at least 10 seconds.
  3.  Turn ignition switch ON.
  4.  Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-372, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Turn ignition switch ON.
  2.  Erase DTC.
  3.  Perform DTC confirmation procedure. Refer to EC-372, "DTC Description".

Is the 1st trip DTC P0604 displayed again? YES >> Replace ECM. Refer to EC-499, "Removal and Installation".

NO >> INSPECTION END

P0603, P062F ECM
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0603 ECM BACK UP/CIRCUIT [Internal Control Module ...

P0605 ECM
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0605 ECM [Internal control module read only memor ...

Other materials:

P0848 transmission fluid pressure SEN/SW B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0848 FLUID PRESS SEN/SW B (Transmission Fluid Pressure Sensor/Switch B Circuit Low) When all of the following conditions are satisfied and this sta ...

Heating and cooling unit assembly
Exploded View Steering Member Heating and cooling unit assembly Steering member  Bolt Nut Automatic Air Conditioning Wiring harness Air mix door duct (LH)  Air mix door duct (RH)  Intake housing gasket  Blower motor Front foot duct (RH) ...

CAN system (type 6)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (connector side an ...

В© 2014-2022 Copyright www.nirogue.com