DTC Description
DTC DETECTION LOGIC
Driving long distances naturally affect fuel gauge level.
This diagnosis detects the fuel gauge malfunction of the gauge not moving even after a long distance has been driven.
DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition |
P0461 | FUEL LEVEL SENSOR (Fuel level sensor ″A″ circuit range/performance) | The output signal of the fuel level sensor does not change within the specified range even though the vehicle has been driven a long distance. |
POSSIBLE CAUSE
FAIL-SAFE
Not applicable
DTC CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC P0461 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.
Is applicable DTC detected? YES >> Perform diagnosis of applicable. Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.PRECONDITIONING
WARNING: When performing following procedure, be sure to observe the handling of the fuel. Refer to FL-2, "General Precaution".
TESTING CONDITION: Before starting component function check, preparation of draining fuel and refilling fuel is required.
Do you have CONSULT? YES >> GO TO 3.
NO >> GO TO 4.
3.PERFORM COMPONENT FUNCTION CHECK
With CONSULT
NOTE: Start from step 10, if it is possible to confirm that the fuel cannot be drained by 30 (7-7/8 US gal, 6-5/ 8 Imp gal) in advance.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-347, "Diagnosis Procedure".
4.PERFORM COMPONENT FUNCTION CHECK
Without CONSULT
NOTE: Start from step 8, if it is possible to confirm that the fuel cannot be drained by 30 (7-7/8 US gal, 6-5/8 Imp gal) in advance.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-347, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC PRIORITY
If DTC P0461 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.
Is applicable DTC detected? YES >> Perform diagnosis of applicable. Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.CHECK COMBINATION METER FUNCTION
Refer to MWI-21, "CONSULT Function (METER/M&A)".
Is the inspection result normal? YES >> GO TO 3.
NO >> Refer to MWI-62, "Component Function Check"
3.CHECK INTERMITTENT INCIDENT
Refer to GI-41, "Intermittent Incident".
>> INSPECTION END
Securing the load
Cargo area luggage hooks
There are luggage hooks located in the cargo
area as shown. The hooks can be used to secure
cargo with ropes or other types of straps.
Do not apply a total load of more than
6.5 lbs. (29 N) to a single metal floor hook
when securing cargo.
WARNING
&nb ...
System
System Description
When the vehicle has reached a speed of 40 km/h (25 MPH) or greater, the BCM
receives a signal transmitted
from the tire pressure sensors installed in each wheel. If the BCM detects low
inflation pressure or a system
malfunction, it sends a signal to the combination meter v ...
Control buttons
Control buttons
The control buttons for the Bluetooth® Hands-
Free Phone System are located on the steering
wheel.
PHONE/SEND
Press the button to
initiate
a Voice Recognition session or
answer an incoming call.
You can also use the button
to interrupt the system feedback
and ...