DTC Description
DTC DETECTION LOGIC
DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition |
P0111 | IAT SENSOR 1 B1 (Intake air temperature sensor 1 circuit range/performance bank 1) | The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the voltage signal of the IAT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state. |
POSSIBLE CAUSE
FAIL-SAFE
Not applicable
DTC CONFIRMATION PROCEDURE
1.INSPECTION START
Is it necessary to erase permanent DTC? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK INTAKE AIR TEMPERATURE (IAT) SENSOR
Monitor item | Condition | Value (Approx.) | |
INT/A TEMP SEN | Temperature [°C (°F)] | 25 (77) |
1.9 - 2.1 (V) |
Is the inspection result normal? YES >> GO TO 5.
NO >> Proceed to EC-207, "Diagnosis Procedure".
3.PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
TESTING CONDITION:
>> GO TO 4.
4.PERFORM DTC CONFIRMATION PROCEDURE
NOTE: Cool the vehicle in an environment of ambient air temperature between −10°C (14°F) and 35°C (95°F).
CAUTION: Never turn ignition switch ON during this procedure.
NOTE: The vehicle must be cooled with the food open.
CAUTION: Never turn ignition switch OFF during idling.
Is 1st trip DTC detected? YES >> Proceed to EC-207, "Diagnosis Procedure".
NO >> INSPECTION END 5.CHECK INTERMITTENT INCIDENT Refer to GI-41, "Intermittent Incident".
>> INSPECTION END
Diagnosis Procedure
1.CHECK INTAKE AIR TEMPERATURE (IAT) SENSOR
Check intake air temperature sensor. Refer toEC-207, "Component Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace mass air flow sensor (with intake air temperature sensor). Refer to EM-24, "Exploded View".
2.CHECK INTERMITTENT INCIDENT
Refer to GI-41, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK INTAKE AIR TEMPERATURE SENSOR
Monitor item | Condition | Value (Approx.) | |
INT/A TEMP SEN | Temperature [°C (°F)] | 25 (77) | 1.9 - 2.1 (V) |
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace mass air flow sensor (with intake air temperature sensor). Refer to EM-24, "Exploded View".
Symptom diagnosis
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
CAUTION:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform
the trouble diagnosis
if any DTC is detected.
NORMAL OPERATING CONDITION
Description
AUTO LIGHT SYSTEM
The headlamp may not be turned ON/OFF immedi ...
Wiring diagram
Wiring Diagram
...
Removal and installation
HOOD
Exploded View
Hood hinge (RH)
Hood
Hood side seal
Hood front seal
Hood center seal
Bumper rubber
Hood insulator
Hood rod clamp
Hood support rod
Hood rod grommet
Hood hinge (LH)
HOOD ASSEMBLY
HOOD ASSEMBLY : Remova ...