Nissan Rogue Service Manual: Output speed sensor

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Removal and installation / Output speed sensor

Exploded View

Exploded View

Transaxle assembly
Output speed sensor
O-ring

Always replace after every disassembly.
: N·m (kg-m, in-lb)
: Apply CVT fluid

Removal and Installation

REMOVAL

Remove engine undercover. Refer to TM-209, "Removal and Installation".
Disconnect the output speed sensor harness connector.
Remove the output speed sensor bolt and remove the output speed sensor.
Remove the O-ring from the output speed sensor.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not reuse O-ring.
Apply CVT fluid to the O-ring.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM-190, "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM-192, "Adjustment".

Primary speed sensor

Exploded View Transaxle assembly O-ring Primary speed sensor : Always replace after every disassembly. : N·m (kg-m, in-lb) : Apply CVT fluid Removal and Installation REMOVAL ...

Differential side oil seal

Exploded View Transaxle assembly Differential side oil seal (left side) Differential side oil seal (right side) (FWD models only) : Always replace after every disassembly. : Appl ...

Other materials:

System description
COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Refer to BCS-79, "BODY CONTROL SYSTEM : Component Parts Location" for detailed instal ...

Installing the upgrade
General information The installation of the upgrade may result in a deletion of software changes such as performance increases that have not been installed by the manufacturer of the vehicle. The installation may take approx. 20 minutes. The installation cannot be terminated. The vehicle can ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-43897-18) Oxygen sensor thread cutter Reconditioning the exhaust system threads before installing ...