Nissan Rogue manuals

Nissan Rogue Service Manual: Oil pump

Exploded View

Exploded View

  1. Front cover (Oil pump body united)
  2.  Outer rotor
  3. Inner rotor
  4.  Oil pump cover
  5. Regulator valve
  6. Regulator valve spring
  7.  Regulator valve plug

CAUTION: Before assembly, apply new engine oil to the parts as shown above.

Removal and Installation

REMOVAL

Remove front cover. Refer to EM-44, "Exploded View".

NOTE: Oil pump is built into front cover.

INSTALLATION

Installation is in the reverse order of removal.

Disassembly and Assembly

DISASSEMBLY

  1.  Remove bolts and oil pump cover.
  2.  Remove inner rotor and outer rotor from front cover.
  3.  After removing regulator valve plug, remove regulator valve spring and regulator valve.

ASSEMBLY

Assembly is in the reverse order of disassembly.

CAUTION: Before assembly apply new engine oil to the parts specified.

Assembly

Inspection

INSPECTION AFTER DISASSEMBLY

OIL PUMP CLEARANCE

Standard : Refer to LU-17, "Oil Pump".

Standard : Refer to LU-17, "Oil Pump".

Inspection after disassembly

Standard : Refer to LU-17, "Oil Pump".

Standard : Refer to LU-17, "Oil Pump".

Inspection after disassembly

Inspection after disassembly

Inspection after disassembly

Standard : Refer to LU-17, "Oil Pump".

REGULATOR VALVE TO OIL PUMP COVER CLEARANCE

Standard : Refer to LU-17, "Oil Pump".

CAUTION:

Regulator valve to oil pump cover clearance

INSPECTION AFTER INSTALLATION

NOTE: If hydraulic pressure inside timing chain tensioner drops after removal and installation, slack in the guide may generate a pounding noise during and just after engine start. However, this is normal. Noise will stop after hydraulic pressure rises.

*Power steering fluid, brake fluid, etc.

Oil cooler
Exploded View  Intake manifold Cylinder block  Clamp  Water hose Water hose clip  Water hose  Oil cooler  Gasket  Oil cooler relief val ...

Service data and specifications (SDS)
Oil Pressure *: Engine oil temperature at 80°C (176°F) Oil Pump Relief Valve Oil Capacity ...

Other materials:

Ecu diagnosis information
ECM Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Numerical values in the following table are reference values. These v ...

P0102, P0103 MAF sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0102 MAF SEN/CIRCUIT-B1 (Mass or volume air flow ″A″ circuit low) An excessively low voltage from the mass air flow sensor is sent to ...

Preparation
Special Service Tool The actual shapes of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...

© 2014-2024 Copyright www.nirogue.com