Nissan Rogue manuals

Nissan Rogue Service Manual: Oil filter

Removal and Installation

REMOVAL

  1.  Remove fender protector side cover (RH). Refer to EXT-28, "FENDER PROTECTOR : Exploded View".
  2.  Drain engine oil. Refer to LU-8, "Draining".
  3.  Remove oil filter using suitable tool (A)..

Removal

: Front

WARNING: Be careful not to burn yourself, as engine oil may be hot.

CAUTION:

Removal

INSTALLATION

  1.  Remove foreign materials adhering to oil filter installation surface.
  2.  Apply new engine oil to the oil seal contact surface of new oil filter.

Removal

  1. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to the specification.

Removal

Oil filter: : 17.7 N·m (1.8 kg-m, 13 ft-lb)

Inspection

INSPECTION AFTER INSTALLATION

  1.  Check the engine oil level. Refer to LU-7, "Inspection".
  2.  Start the engine, and check that there is are no leaks of engine oil.
  3.  Stop the engine and wait for at least 5 minutes.
  4.  Check the engine oil level, and adjust the level (if necessary). Refer to LU-7, "Inspection".
Engine oil
Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 5 minutes before checking. ...

Removal and installation
...

Other materials:

Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING After removing the bolts and nuts, separate the mating surface and remove the liquid gasket using Tool (A). Tool Number : KV10111100 (J-37228) CAUTION: Be careful not to damage the mating surfaces.  In areas where the cutter is difficult to use, u ...

C1769 configuration setting
DTC Description This procedure must be performed:  After replacement of BCM. DTC DETECTION LOGIC DTC Display Item Malfunction detected condition C1769 CONFIG SETTING (Configuration setting) Tire air pressure monitoring system configuration cannot be p ...

VIN registration
Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M). Work Procedure 1.CHECK VIN Check the VIN of the vehicle and note it. ...

© 2014-2022 Copyright www.nirogue.com