Nissan Rogue manuals

Nissan Rogue Service Manual: Occupant classification system control unit

Nissan Rogue Service Manual / Restraints / SRS Airbag / Removal and installation / Occupant classification system control unit

Removal and Installation

OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT

WARNING:

Removal

  1.  Remove occupant classification system control unit screws (A).
  2.  Disconnect the harness connector (B) and remove occupant classification system control unit (1).

CAUTION:

Removal

Installation

Installation is in the reverse order of removal.

WARNING:

CAUTION:

OCCUPANT CLASSIFICATION SYSTEM SENSORS

Removal

The occupant classification sensors are part of the front passenger seat frame. For removal and installation of the front passenger seat frame. Refer to SE-35, "PASSENGER SIDE : Removal and Installation".

Air bag diagnosis sensor unit
Exploded View Diagnosis sensor unit Front Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait ...

 SRS Airbag Control System
...

Other materials:

U1000 CAN COMM circuit
DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause U1000 CAN COMM CIRC [U1000] When combination meter is not transmitting or receiving CAN communication signals for 2 seconds or more. CAN communication system D ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

© 2014-2024 Copyright www.nirogue.com