Nissan Rogue Service Manual: O/D off indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.
Is the inspection results normal? YES >> INSPECTION END
NO >> Go to TM-181, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC (TCM)
With CONSULT
- Turn ignition switch ON.
- Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 2.
2.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 3.
3.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
- Shift the selector lever to “D” position.
- Select “Data Monitor” in “METER/M&A”.
- Select “O/D OFF IND”.
- Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-24, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 4.
4.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Select “Data Monitor” in “TRANSMISSION”.
- Select “SPORT MODE SW”.
- Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 52, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check overdrive control switch circuit. Refer to TM-178, "Diagnosis Procedure".
Overdrive control switch
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YE ...
Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
Start the engine.
Shift selector lever.
Check that the selector lever position and the shift position
...
Other materials:
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".
1. CHECK FUSE
Check that the following fuse is not blown.
Terminal No.
Signal name
Fuse No.
161
BCM power sup ...
Wiring diagram
HEADLAMP
Wiring Diagram
DAYTIME LIGHT SYSTEM
Wiring Diagram
AUTO LIGHT SYSTEM
Wiring Diagram
FRONT FOG LAMP SYSTEM
Wiring Diagram
TURN SIGNAL AND HAZARD WARNING LAMP SYSTEM
Wiring Diagram
...
P0451 EVAP control system pressure sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0451
EVAP SYS PRES SEN
(Evaporative emission system pressure
sensor/switch range/performance)
ECM detects a sloshing signal from the EVAP contr ...
