Nissan Rogue Service Manual: Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies based on engine speed.
Fuel cut will be operated until the engine speed reaches 1,500 rpm, then fuel cut will be cancelled.
NOTE: This function is different from deceleration control listed under Multiport Fuel Injection (MFI) System, EC-34, "MULTIPORT FUEL INJECTION SYSTEM : System Description (with automatic air conditioner)" or EC-37, "MULTIPORT FUEL INJECTION SYSTEM : System Description (with manual air conditioner
Information display is malfunctioning
Diagnosis Procedure
1.CHECK DTC WITH ECM
Check that DTC is not displayed.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Perform trouble diagnosis relevant to DTC indicate ...
Periodic maintenance
IDLE SPEED
Inspection
1.CHECK IDLE SPEED
With CONSULT
Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT.
With GST
Check idle speed with Service $01 of GST.
>> IN ...
Other materials:
The liftgate open warning continues displaying, or does
not display
Description
The liftgate open warning is displayed continuously even though the
liftgate is closed.
The liftgate open warning is not displayed even though the
liftgate is open.
Diagnosis Procedure
1.CHECK BCM INPUT SIGNAL
Check the BCM input signal. Refer to DLK-149, "Com ...
DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
Refer to LAN-8, "System Description".
DTC Logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected, perhaps
during a repair. Confirm
that there are actual CAN diagnostic symptoms and a present DTC by p ...
Door mirror remote control switch
Removal and Installation
REMOVAL
Release pawls using a suitable tool and remove front door pull handle
(LH). Refer to INT-15, "Exploded
View".
Release pawls (B) using a suitable tool and remove door mirror
remote control switch (1).
Remove screws (A) and d ...
