The following voice commands are available for the Navigation System:
For additional information about these commands, refer to the separate Navigation System Owner’s Manual.
Audio system voice commands
To access the audio system voice commands:
For additional information about the audio system, refer to “Audio system” in this section.
Information voice commands
The following voice commands are available for the information functions of the Navigation System:
For additional information about these commands, refer to the separate Navigation System Owner’s Manual.
My Apps Voice Commands
Many Apps can be accessed using this voice command. For additional information, refer to “NissanConnectSM with Mobile Apps” in this section.
Help voice commands
The following voice commands can be spoken to have the system provide instructions and tips for using the NISSAN Voice Recognition system.
Troubleshooting guide
The system should respond correctly to all voice commands without difficulty. If problems are encountered, follow the solutions given in this guide for the appropriate error. Where the solutions are listed by number, try each solution in turn, starting with number one, until the problem is resolved.
Symptom/error message | Solution |
The system responds “Command Not Recognized” or the system fails to recognize the command correctly. |
NOTE: If it is too noisy to use the phone, it is likely that voice commands will not be recognized.
|
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".
1. CHECK FUSE
Check that the following fuse is not blown.
Terminal No.
Signal name
Fuse No.
161
BCM power sup ...
TPMS
Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
Diagnosis
items
Symptom
(Power switch ON)
Low tire pressure warning lamp
Cause
Action
Low tire pressure
warning
lamp
The low tire pressure
warning lamp
illuminates for 1
second, then turn ...
Low tire pressure warning lamp does not turn on
Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is
Turned
On
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS sensor IDs
&n ...