Nissan Rogue manuals

Nissan Rogue Service Manual: Mudguard

Exploded View

Exploded View

  1. Front mud guard
  2.  Rear mud guard

Removal and Installation

FRONT MUD GUARD

Removal

Remove front mud guard screws and remove front mud guard.

Installation

Installation is in the reverse order of removal.

REAR MUD GUARD

Removal

Remove rear mud guard screws and remove rear mud guard.

Installation

Installation is in the reverse order of removal.

Exploded View - Center Mudguard

Exploded View - Center Mudguard

  1. Center mudguard

Clip
Front

Removal and Installation - Center Mudguard

REMOVAL

  1.  Partially remove over fender moldings. Refer to EXT-30, "FRONT OVER FENDER : Exploded View".
  2.  Remove screws (A) from center mudguard (1).

Removal

  1. Remove center mudguard center mudguard bolts (A) from center mudguard (1).

    : Front

Removal

  1. Release center mudguard clips with a suitable tool (A) and remove the center mudguard (1).

    : Clip

CAUTION: Release clips slowly and carefully.

Removal

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Over fender
FRONT OVER FENDER FRONT OVER FENDER : Exploded View Front fender protector  Front fender  Front over fender molding Clip FRONT OVER FENDER : Removal and Installation REM ...

Under cover
Exploded View Floor under cover (RH) Engine under cover Floor under cover (LH) ENGINE UNDER COVER ENGINE UNDER COVER : Removal and Installation REMOVAL  Remove engine under ...

Other materials:

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT  Turn ignition switch ON.  Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.  Start engine.  After engine stalls, crank it two or three times to ...

General information
The permissible trailer loads, axle weights, drawbar node weights, and the permissible gross vehicle weight are specified in the technical data. The vehicle is equipped with an enhanced suspension system on the rear axle and, depending on the vehicle type, with a more powerful cooling system. When ...

Power generation voltage variable control system operation inspection
Diagnosis Procedure Regarding Wiring Diagram information. Refer to CHG-7, "Wiring Diagram". CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the response speed of the vol ...

© 2014-2022 Copyright www.nirogue.com