Nissan Rogue manuals

Nissan Rogue Service Manual: Moonroof switch

Description

Transmits switch operation signal to moonroof motor and sunshade motor assembly.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to RF-17, "Wiring Diagram".

1.CHECK MOONROOF SWITCH INPUT SIGNAL

  1.  Turn ignition switch ON.
  2.  Check voltage between moonroof motor assembly harness connector and ground.

Check moonroof switch input signal

Is the inspection result normal? YES >> Inspection End.

NO >> GO TO 2.

2.CHECK MOONROOF SWITCH CIRCUIT

  1.  Turn ignition switch OFF.
  2.  Disconnect moonroof motor assembly connector and moonroof switch connector.
  3.  Check continuity between moonroof motor assembly harness connector and moonroof switch harness connector.

Check moonroof switch circuit

  1. Check continuity between moonroof motor assembly harness connector and ground.

Check moonroof switch circuit

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the harness.

3.CHECK MOONROOF SWITCH GROUND CIRCUIT

Check continuity between moonroof switch harness connector and ground.

Check moonroof switch ground circuit

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the harness.

4.CHECK MOONROOF SWITCH

Check moonroof switch.

Refer to RF-32, "Component Inspection".

Is the inspection result normal? YES >> GO TO 5.

NO >> Replace moonroof switch. Refer to RF-64, "Removal and Installation".

5.CHECK INTERMITTENT INCIDENT

Refer to GI-41, "Intermittent Incident".

>> Inspection End.

Component Inspection

MOONROOF SWITCH

1. CHECK MOONROOF SWITCH

  1.  Turn ignition switch OFF.
  2.  Disconnect moonroof switch.
  3.  Check continuity between moonroof switch terminals.

Check moonroof switch

Is the inspection result normal? YES >> Moonroof switch is OK.

NO >> Replace moonroof switch. Refer to RF-64, "Removal and Installation".

Power supply and ground circuit
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-50, "Wi ...

Door switch
WITH INTELLIGENT KEY WITH INTELLIGENT KEY : Component Function Check 1.CHECK FUNCTION  Select "DOOR LOCK" of "BCM" using CONSULT.  Select "DOOR SW-DR", ...

Other materials:

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...

The ambient temperature display is incorrect
Description The displayed outside air temperature is higher than the actual temperature.  The displayed outside air temperature is lower than the actual temperature.  Outside air temperature is not indicated. Diagnosis Procedure 1.CHECK AMBIENT SENSOR SIGNAL CIRCUIT Chec ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM  Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).  Check operation condition of the ...

В© 2014-2024 Copyright www.nirogue.com