Nissan Rogue Service Manual: Moonroof motor assembly
Exploded View
- Panoramic roof glass
- Glass lid
- Side trim covers (LH/RH)
- Front drain hose front (LH/RH)
- Moonroof motor assembly
- Sunshade motor assembly
- Moonroof front bracket (LH/RH)
- Moonroof rear bracket (LH/RH)
- Drain hose rear (LH/RH)
- Moonroof unit assembly
- Rear trim (LH/RH)
Front
Removal and Installation
REMOVAL
- Close glass lid.
- Remove the headlining. Refer to INT-30, "Removal and Installation".
- Remove moonroof motor assembly screws (1).Front
- Disconnect harness connector (A) and remove moonroof motor
assembly (2) from moonroof unit assembly front end rail.
CAUTION: Do not run the removed moonroof motor assembly as a single unit.
INSTALLATION
- Move moonroof motor assembly laterally little by little so that the
gear is completely engaged into the wire
on the moonroof unit assembly, and the mounting surfaces become parallel.
Install the moonroof motor
assembly screws and tighten.
CAUTION: Before installing the motor, be sure to place the link and wire assembly in the symmetrical and fully closed position.
NOTE: If necessary, insert a suitable tool into the drive key and rotate right or left slightly to assist in complete moonroof motor gear alignment.
- Remainder of installation is in the reverse order of removal.
- Synchronize moonroof motor assembly with moonroof unit assembly. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Panoramic roof glass
Exploded View
Panoramic roof glass
Glass lid
Side trim covers (LH/RH)
Front drain hose (LH/RH)
Moonroof motor assembly
Sunshade motor assembly
Moonroof front bracke ...
Moonroof unit assembly
Inspection
WIND DEFLECTOR
Open glass lid fully.
Visually check for proper installation, damaged/deteriorated components,
or foreign objects within mechanism.
Correct as required for smooth ...
Other materials:
Occupant classification system control unit
Removal and Installation
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Do not use air tools or electric tools for servicing.
Removal
Re ...
Rear power window switch
Description
Rear power window motor will be operated if rear power window switch is
operated.
Component Function Check
1. CHECK REAR POWER WINDOW SWITCH FUNCTION
Check rear power window motor operation with rear power window switch.
Is the inspection result normal?
YES >> Rear power ...
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
dr ...
